Repair most Bent Alloy Car and Truck wheels (steel or Aluminum alloy rims). Repair 14 inch through 24 inch and even larger wheels with our Alloy Wheel Straightener.
  Our equipment for repairing a bent rim is easy to use, comes with instructions and is a low cost investment for any automotive shop.
The Wheel Straightener will pay for itself in no time at all. Most shops charge between $125.00 and $150.00 to repair one bent wheel. Repairing only one bent wheel a day will generate over $30,000 a year in sales.

   We do not just make and sell these straighteners, we also use them every day ourselves. We have been using this Wheel Straightener along side our Alloy Wheel Refinishing System for well over 24 years.
     The half-moon dies are designed to fit the wheel perfectly for straightening. The larger die is sized, shaped and tapered to support the non bend side. This specific shape prevents egg shaping the wheel and allows you to use just a standard propane torch for heat.(not supplied)

    Our system will straighten most bends and dents commonly caused by bad roads and curbs. The system can be used on both sides of the wheel as shown because of the design of the dies. Right side up for the face of a wheel or upside down for the back side. Tapered just right to give you maximum contact with the rim for both support and straightening.
    The two dies will work on most 14" inch through 24"inch and larger rims. The design of some rims make working on the face of the wheel either hard to do or impossible. Every wheel is different. We included other parts to the kit to fit into as many areas of a wheel as possible. Some of which you may never used but are there just in case.